Router mode: DHCP and NAT (NAT Port Mapping Protocol enabled)Īll the iDevices I'm using are updated to their latest OS version.tried auto and manual 2.4Ghz and 5Ghz channels selection (by scanning the other networks around). Now you can reach data rates of up to 1.3 Gbps1. My AirPort Extreme is on firmware 7.6.4, set up as follows: With three-stream 802.11ac technology, the AirPort Extreme Base Station takes Wi-Fi speeds over the top. I've also changed all UTP cables to be CAT.5e, in order to support gigabit speeds. I tested the connection by directly sticking the cable into the MBP (via the thunderbolt ethernet adapter) and got 850 / 200 Mbps, so the connection from my provider does work as expected. Since the low speeds are consistent over wired / WiFi (I was expecting the Mac Mini to outperform the others, since its on gigabit ethernet), this will not be a discussion about how to select the best channel (tried auto or manual setup, with it on different channels) or change its placement (this is consistent even with the MBP right next to the router) to get better reception. The low speeds happen both on WiFi and wired (I have an iMac, a MBP, an iPhone 6s and an iPad Mini that connect via WiFi, on the 5Ghz network and a Mac Mini that is wired into the router), with my wireless devices getting full strength signal and connecting at 450 Mbps. The best I ever got were around 180 / 200 Mbps, but that only happened once. My plan is 1000 / 200 Mb (down / up - Romanian RCS & RDS, Fib), however, I'm getting averages of 90 / 80 Mb speeds on. I have an AirPort Extreme A1408 (5th Gen), that is connected to the internet via a UTP cable (wall plug, the internet provider has its routers in the basement of the apartment building).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |